|
|
Post by grumps on Feb 17, 2015 18:57:10 GMT
As above. I need to clutch boss (centre bit) for a '95 Divvy 600
I have gone and broken off a spring screw inside. Unless I can get it out I'll need a 2nd hand boss unit
Anyone got one?
Thanks
David
|
|
|
|
Post by bobh on Feb 18, 2015 18:43:15 GMT
Crickleymal?  |
|
|
|
Post by crickleymal on Feb 18, 2015 21:24:35 GMT
Could be. I need to source a replacement engine but some parts may well be available.
|
|
|
|
Post by grumps on Feb 19, 2015 9:12:57 GMT
I have tracked a scrapper Clutch boss. I notice in the manual that there are dimples marked on the boss and cover plate. The manual says to line these up.
Is this because they are balanced together? If so, a mismatched pair may cause vibration.
Does anyone know?
|
|
|
|
Post by biblebasher on May 16, 2015 13:59:35 GMT
i have a 96 bottom end if you need a complete clutch.
|
|
|
|
Post by grumps on May 17, 2015 18:29:59 GMT
Thanks...I bought a basket from a scrapper.
Cheers
David
|
|
|
|
Post by CD on May 17, 2015 21:40:32 GMT
Use a thrust washer on both sides of the needle roller washer and lots of high temperature grease. The release bearing sees very little oil.
Also check the operating spindle bearings. These also run dry, damage the seal and let water into the engine.
|
|
|
|
Post by grumps on May 18, 2015 15:19:31 GMT
Thanks. Engine is back together now. I did grease the bearing and spindle. I hope it's enough!
|
|
