|
|
Post by stukeith on Jun 30, 2013 23:18:05 GMT
How do I remove the ignition barrel? The manual says just use a philips head driver and undo. However dont have anything. There is just a domed head and nothing to undo with.
Help! I have a new ignition to fit.
|
|
|
|
Post by ContourMac on Jul 1, 2013 7:45:46 GMT
They are security bolts fitted as standard.
carefully drill the heads off the security bolts then remove the old barrel and remaining studs.
Fit the new ignition with standard hex bolts.
|
|
|
|
Post by neilmud Lord Protector on Jul 1, 2013 8:39:37 GMT
If you log on to crime.gov & look for your local hotspot take your bike there & park up.Hide round the corner & the local removal service will have it of in seconds  Neil |
|
|
|
Post by teejayexc on Jul 1, 2013 8:43:19 GMT
If you log on to crime.gov & look for your local hotspot take your bike there & park up.Hide round the corner & the local removal service will have it of in seconds Neil Perhaps you could take your Hardley there too ?  |
|
|
|
Post by HRHpenfold on Jul 1, 2013 8:57:24 GMT
use a hammer and centre punch, if that don't work, then remove top yoke and drill out!
|
|
|
|
Post by stukeith on Jul 3, 2013 17:31:35 GMT
Finally got it out. Drilling didn't work, even took to an engineering place and they couldn't get them out. In end I dremmeld the ally off and cut heads off, then removed bolts with mole grips.
|
|
