|
|
Post by daveo on Oct 17, 2009 11:01:01 GMT
as any one changed exhaust from 4..2 to a 4into 1 ?
|
|
|
|
Post by DahDit on Oct 22, 2009 21:00:41 GMT
For a 600?
|
|
|
|
Post by Jake on Nov 1, 2009 17:20:45 GMT
Yes.. Standard one was pretty rotten when i bought the bike, after a few months it burst at the point where the clips go round the silencer stems so i had to get a Motad 4-1.
Stainless so it shouldn't happen again.
Only trouble is i have to stop the centre stand coming up too hard as the rubber bung on the left side has nothing to bump not so if i let the stand ping up full force theres a horrible DING as the arm going across it hits the pipes underneath.
Looks good, sounds slightly throatier than standard but i noticed no real power gains.
|
|
|
|
Post by Padster on Nov 1, 2009 23:57:06 GMT
There is a bracket supplied with the Motad that has a rubber bung on it to stop it hitting the pipes.
|
|
|
|
Post by Padster on Nov 2, 2009 11:36:06 GMT
Sorry the bracket doesn't have the bung on it is the stand.
|
|
|
|
Post by Jake on Nov 3, 2009 22:09:44 GMT
Its not a major problem I got into the habit of just putting my right foot down right behind the stand and letting it up into my lower leg.. Its just when other people take it off. Also occasionally over speed bumps i hear it sag and then 'ding' back up a little  |
|
