|
Post by ta04pro on May 9, 2009 11:39:18 GMT
Wonder if anyone can give me part numbers for the rear suspension pivot bearings on the 1995 D900?
Would people recommend original parts, or would another source be available?
Many thanks
Dave
|
|
|
Post by CD on May 9, 2009 13:08:22 GMT
I would also replace the suspenson rocker bearings in the swing arm while you are at it.
They are standard sizes and have been discussed recently so worth digging back a few weeks.
|
|
|
Post by ta04pro on May 9, 2009 15:11:12 GMT
I would also replace the suspenson rocker bearings in the swing arm while you are at it. They are standard sizes and have been discussed recently so worth digging back a few weeks. i did try the search function but was unable to find anything. Any ideas where the thread is?
|
|
|
Post by CD on May 9, 2009 15:33:48 GMT
|
|
|
Post by high peak fazer on May 10, 2009 15:45:48 GMT
Hi Replaced my bearings 3 years ago but due to poor design and not greasing them on a regular basis some of the bearings are shot . Ebay came to the rescue i got the pivot casting complete with bearings from a FZS 600 Fazer Y reg 10700 miles for £17 delivered the whole thing was very clean and bearings in excellent condition I will have to remember to re grease every few months,as i ride to work every day. Only a hand full of days missed through the winter months
Martyn
|
|
|
Post by CD on May 11, 2009 12:58:31 GMT
On my 900, the front rocker bearing is going home (probably because it gets the most movement), but middle pair are always soapy. I intend to fit a grease nipple between the two needle rollers. The others are not so clever so when they eventually go I plan to use some DX bushes. If they are available in suitable sizes I'll post the details. DX bearings are designed for low angular (rocking) movement with little or no lubrication. They are also drilled for grease nipples.
|
|