|
Post by willed on Nov 3, 2017 18:24:22 GMT
Hi All, I'm Will from Northants and just picked up a 1999 divvy 900 which needs a bit of TLC. One of the issues is the choke which isn't working. On investigation the problem is its missing the choke cable clamp (the screw and washer are in place). The parts diagram shows the clamp but it isn't numbered and wemoto etc therefore can't place one for me. Anybody know where I might be able to pick one up? Any assistance would be greatly appreciated. Cheers.
|
|
|
Post by m40man on Nov 4, 2017 13:11:52 GMT
|
|
|
Post by willed on Nov 4, 2017 16:25:27 GMT
Thanks m40man although I'm assuming they'll need a pattern for it in order to make it as its got a couple of tabs one of which curves upwards.
|
|
|
Post by m40man on Nov 4, 2017 16:49:27 GMT
To be honest, if you have the screw then you could fashion a simple clamp. Drill a hole for the screw. Even a flat piece of metal would prob do, but better if you put a bit of a curve on it. One of the tabs simply helps to retain the thing in place, against the pull created by operating the cable. (I'll bet you could even cable-tie it if pushed).
|
|
|
Post by willed on Nov 4, 2017 19:29:36 GMT
I hadn't thought of that. Maybe even a washer or two underneath the cable on top of the plate to raise the cable slightly then a wider one on top to screw down onto the cable. Thanks for helping me to think outside the box. Nice one!
|
|