|
|
Timing
Nov 25, 2012 14:54:48 GMT
Post by bigbuck on Nov 25, 2012 14:54:48 GMT
Hi All, anyone got a picture of the TDC setting on a D6 please as I'm about to start stripping my engine top end to do the base gasket??? I've got Reapers DVD's but they're not on them.
Many thanks, Rich
|
|
|
|
Timing
Nov 25, 2012 16:51:40 GMT
Post by alan292 on Nov 25, 2012 16:51:40 GMT
Best I can do is a couple of photos from the manual Buck....hope these help   |
|
|
|
Timing
Nov 25, 2012 16:58:21 GMT
Post by bigbuck on Nov 25, 2012 16:58:21 GMT
Cheers Alan, much appreciated and when I sa your post I went straight to my Haynes and found the same pic, now noted for the future.
thanks again mate
|
|
|
|
Timing
Nov 25, 2012 17:03:03 GMT
Post by alan292 on Nov 25, 2012 17:03:03 GMT
|
|
|
|
Timing
Nov 27, 2012 22:18:25 GMT
Post by CD on Nov 27, 2012 22:18:25 GMT
When you set the cams make sure the correct cylinder is at TDC. Do it wrong and the cam timing will be 180 degrees (360 at the crank) out of phase
|
|
|
|
Timing
Nov 28, 2012 19:11:54 GMT
Post by bigbuck on Nov 28, 2012 19:11:54 GMT
Cheers Cd, I've done that and also paint marked both cams so as not to get them wrong when I re-build.
Thanks again Rich
|
|
|
|
Timing
Nov 28, 2012 20:58:09 GMT
Post by CD on Nov 28, 2012 20:58:09 GMT
The cams might have some means of locking them in the correct positions. I'm pretty sure the 900 does.
|
|
