Post by bo6o on Sept 22, 2011 6:05:28 GMT
So, as I wrote in the other thread, my thermo switch broke in the hole where it is plugged and I'm going to just seal the hole(can't find working spare parts and can't remove what's left over in the hole).
My idea is to connect the solenoid, that's letting the oil in the carb system to a regular switch, so that I can start the heater manually.
I looked at the wiring diagram, but I don't get it...
There are two wires coming out of the solenoid - how should I connect them, through a switch(where to plug the other ends) so when it's cold - I just press the switch and the carbs start heating, I switch it off - and they stop...
My idea is to connect the solenoid, that's letting the oil in the carb system to a regular switch, so that I can start the heater manually.
I looked at the wiring diagram, but I don't get it...
There are two wires coming out of the solenoid - how should I connect them, through a switch(where to plug the other ends) so when it's cold - I just press the switch and the carbs start heating, I switch it off - and they stop...