pwgun
Scooter Rider
Trying to get my look... harder than i would have thought!!?
Posts: 55
|
Post by pwgun on Aug 23, 2011 19:09:57 GMT
New to diversion and bikes in general. Can i add a single exhaust can, from any 600cc bike, say a cbr600, with req adaptions, or does it have to be the correct twin system. ( mine has corroded inside and out)  I ahve a xj600s diversion 1993 thanks |
|
|
|
Post by sparky392 on Aug 23, 2011 21:58:28 GMT
You can fit a 4-1 system, Delkevic do 1 for around £200 last time I looked, should find them on ebay easy enough
|
|
pwgun
Scooter Rider
Trying to get my look... harder than i would have thought!!?
Posts: 55
|
Post by pwgun on Aug 24, 2011 20:57:50 GMT
thanks, will have a look.
|
|
|
|
Post by DahDit on Aug 24, 2011 22:14:59 GMT
Going from a twin Yamaha set up to an aftermarket 4-1, you'll need to check that there will be a bump stop for the centre stand, or you may end up having to take it off. I'm sure Sparky will confirm if the Delkevic caters for it.
|
|
|
|
Post by bobh on Aug 25, 2011 8:39:36 GMT
From memory, the Delkevitch setup comes with a bit of bent steel that bolts to the n/s exhaust hanger to act as a centre stand stop. It would be dead easy to make one up if it's missing.
|
|
|
|
Post by sparky392 on Aug 25, 2011 8:55:57 GMT
Bob is correct, it does come with a bit of bent steel as did my motad exhaust. my mate didnt fit his as he only has side stand. We used his to make an exhaust bracket for my scooter as it was missing in kit.
|
|
