|
|
Post by stevie16v on Apr 5, 2011 14:02:44 GMT
I took my clutch cover off to do the roll pin mod, dont have the socket for the main nut. Putting it back together. Firstly my torque wrench packed it in, So i've had to guess the tension for the pressure plate bolts. Also, when i put it all back together, the lever doesn't spring back at the handle bar side. Any ideas?
|
|
|
|
Post by stevie16v on Apr 5, 2011 17:29:32 GMT
Sorted
|
|
|
|
Post by dave on Apr 23, 2011 11:58:36 GMT
hi fella i to doing my clutch can i please ask how you got the pressure plate bolts done up an how i would go about this as i dont have a torque wrench thanks dave
|
|
|
|
Post by stevie16v on Apr 23, 2011 12:06:58 GMT
Dave, my torque wrench packed in. I just done the up until you feel it touching the backing plate. 8nm isn't a lot so just a very small tweak, or you WILL snap the bolt!
|
|
|
|
Post by amorti on Apr 24, 2011 7:21:45 GMT
Be careful to do the spring retaining bolts in a circle. If you try to tighten just the first one on its own, you'll break something.
|
|
|
|
Post by stevie16v on Apr 24, 2011 8:20:01 GMT
Meant to say that aswell. I done mine in a cross cross pattern
|
|
|
|
Post by amorti on Apr 25, 2011 7:36:36 GMT
Yes, in a cross pattern is even better! [facepalm]
|
|
